← 공개 라이브러리

Hand sanitizer dispenser inspection and refill

by MASTER

Routine to inspect and refill all hand sanitizer dispensers across the library to maintain availability and hygiene; perform weekly or whenever low-stock is suspected.

Fecit 앱에 저장하기
이 루틴을 Fecit 앱에서 열어 내 라이브러리에 추가하세요.

내용 미리보기

Hand sanitizer dispenser inspection and refill

Routine to inspect and refill all hand sanitizer dispensers across the library to maintain availability and hygiene; perform weekly or whenever low-stock is suspected.

⏱ 30분 ★ 쉬움
현재

Several dispensers at entrances, stacks, study rooms, and staff areas have varying fill levels, some pumps are sticky or leaking, and status is not logged.

난관

Some dispensers are locked or mounted above reach requiring a key or step stool, refill bottles use mixed connector types that may not fit every pump, and visitor traffic can interrupt rounds.

기대

Every dispenser is refilled to at least 80% or fitted with a fresh refill, pumps operate smoothly, surfaces are wiped dry, and each location's status is recorded.

재료
  • • Hand sanitizer refill bottles — 5 bottle
  • • Disposable nitrile gloves — 1 box
  • • Paper towels — 1 roll
도구
  • • Dispenser key — 1
  • • Small step stool — 1
  • • Checklist or mobile device — 1
단계
  1. 01
    Gather supplies and plan route
    Collect refill bottles, gloves, paper towels, dispenser key, and clipboard or device, then review the map/list of all dispenser locations to set an efficient route.
    ⏱ 5분
  2. 02
    Inspect each dispenser
    Visit every dispenser on the route and record fill level as Empty (<10%), Low (10–50%), or OK (>50%), test the pump (works/sticky/leaks), and note physical damage on the checklist.
    ⏱ 10분
  3. 03
    Refill or replace units
    For dispensers below 80% unlock if necessary, install a fresh refill or pour sanitizer until the container reads ~80% full, test the pump 3 times, and discard empty bottles in waste.
    ⏱ 5분
  4. 04
    Clean and secure dispensers
    Wipe nozzle and surrounding surfaces dry with paper towel, remove any floor residue to prevent slip hazards, tighten mounts and close locks.
    ⏱ 5분
  5. 05
    Log results and restock storage
    Update the checklist or device with final fill levels and any repairs needed, report broken dispensers to facilities, return unused supplies to storage, and note remaining bottle count.
    ⏱ 5분