Label printer ribbon replacement and test print

by MASTER

Replace a spent or damaged thermal transfer ribbon and verify print quality after replacement; use when labels print faint, streaked, or blank.

Fecit 앱에 저장하기

이 루틴을 Fecit 앱에서 열어 내 라이브러리에 추가하세요.

앱에서 열기 App Store Play Store

내용 미리보기

Label printer ribbon replacement and test print

Replace a spent or damaged thermal transfer ribbon and verify print quality after replacement; use when labels print faint, streaked, or blank.

⏱ 22분 ★ 보통

현재

The label printer has a spent or torn thermal transfer ribbon and recent labels print faint, streaked, or blank.

난관

The ribbon can be installed backwards or misaligned in the tight ribbon path, causing faint prints, creases, or jams; small fasteners or unclear alignment marks make correct seating hard to verify.

기대

The printer produces crisp, fully inked labels on the first test print with no ribbon wrinkles or jams.

재료

• Thermal transfer ribbon (compatible model) — 1 roll
• Isopropyl alcohol wipe — 1 wipe

도구

• Phillips screwdriver — 1
• Lint-free cloth — 1

단계

01

Power down and access ribbon compartment

Turn the printer off, unplug power and data cables, and open the top cover or access panel using the latch or screwdriver so the ribbon area is fully visible.

⏱ 2분
02

Remove old ribbon

Cut any securing tape, lift both ribbon spools straight out of their hubs, remove loose ribbon from the print path, and place the used ribbon into waste or recycling.

⏱ 5분
03

Install new ribbon and align path

Place the supply and take-up spools on the correct hubs, thread the ribbon over the printhead following the printed path markings, pull the ribbon taut with no twists, and seat spools until they click into the hubs.

⏱ 10분
04

Close, power on, and test print

Close the cover, reconnect power, turn the printer on, run the built-in calibration or send two test labels from the software, and inspect prints for full coverage and correct alignment; if faint, re-seat ribbon and repeat one test.

⏱ 5분